KB Electronics KBDA-42 - Manual (Page 29)

28
FIGURE 21 – FLOW CHART TO PROGRAM THE DRIVE TO DISPLAY CUSTOM UNITS “012.0”
Set Frequency Flashes
("FWD", "STOP", "Hz" LEDs On)
POWER ON
Digit Flashes
Group No.
("PGM" LED On) Function No.
to Display
Press Program Key
to Increase Digit
Press Up Key 4 Times
Press Up Key 1 Time
to Increase Digit
Custom Units
Code No.
Digit Flashes
to Read
Press Read Key
Custom Units Value Setting
Digit Flashes
Custom Units 2
Press Shift Key 1 Time
to Move Digit Digit Flashes
Custom Units Press Up Key 2 Times
to Increase Digit
Custom Units
Digit Flashes
which Confirms Programming
"End" Momentarily Displays
Code No.
Digit Flashes
Custom Units Custom Units Display
Code No.
Digit Flashes
to Increase Digit
Press Up Key 1 Time
Custom Units Display Code
Press Read Key
to Read to Increase Digit
Press Up Key 1 Time
Whole Numbers Code 3
Digit Flashes
Custom Units Display
One Decimal Place Code
Digit Flashes
Custom Units Display
Function No.
Custom Units Display
Digit Flashes
("FWD", "STOP" LEDs On)
to Save New Code
Press Enter Key
which Confirms Programming
"End" Momentarily Displays
to Change Display
Press Display Key Custom Units Value Flashes 4
(”001.0” = 5 Hz
Display Mode
Code No.
Digit Flashes
Press Enter Key
to Save New Code
Digit Flashes
Display Mode
Custom Units Code
"End" Momentarily Displays
which Confirms Programming
Function No.
Display Mode
Digit Flashes Digit Flashes
Frequency Code 1
Display Mode Press Up Key 2 Times
to Increase Digit to Read
Press Read Key
Display Mode Code
Notes: 1. The factory setting of Display Mode (Function
No. 4.00) is Frequency (“0000”). 2. The factory setting
of Custom Units Significant Digits (Function No. 4.01) is
“0100”. 3. The factory setting of Custom Units Display
(Function No. 4.02) is Whole Numbers (“0000”). 4. The
Custom Unit setting “012.0” will be displayed at full
speed.