IAI America IK Series - Manual (Page 10)

Crossed-type base fixed: Single slider type
IK2-S(P)YB †††††S
DWG. No. GMM07-057E 2/2
7 Arrange the wires so that each axis will not contact the cables and
connectors when the axis is moved over its entire stroke.
(Note) If you want to move the actuator with brake by hand, connect the
controller and supply the power and then set the brake release switch to
the release (RLS) side.
* Refer to “Cable affixing method: GMM07-060” for affixing of cables.
Y-axis (axis 1): With cable bearer / Z-axis (axis 2): Without cable bearer
Arrange the wires so that each axis will not contact the cables and
connectors when the axis is moved over its entire stroke.
(Note) If you want to move the actuator with brake by hand, connect the
controller and supply the power and then set the brake release switch to
the release (RLS) side.
* Refer to “Cable affixing method: GMM07-060” for affixing of cables.
Y-axis (axis 1): With cable bearer / Z-axis (axis 2): With cable bearer