IAI America RCP3-RA2BR - Manual (Page 36)

30
8. Installation Environment and Storage Environment
8. Installation Environment and Storage Environment
8.1 Installation Environment
Install the actuator in an environment meeting the following conditions:
x Is a normal environment for assembly work where there is not much dust.
(If the actuator is used in an environment where dust is floating in air, the life of the actuator will
become significantly shortened.)
x Not exposed to direct sunlight
x The machine does not receive radiated heat from large heat sources such as heat treatment furnaces.
x Surrounding air temperature of 0 to 40°C
x Humidity of 85% or below, non-condensing
x Not subject to corrosive or flammable gases
x Not subject to oil mist or cutting fluid
x Not subject to impact or vibration
x Not subject to significant electromagnetic waves, ultraviolet light or radiation
x This product is not designed to provide chemical resistance.
In general, the environment shall be one where the operator can work without wearing protective gears.
Open space required for maintenance inspection
8.2 Storage/Preservation Environment
The storage/preservation environment conforms to the installation environment. If the robot is to be
stored/preserved for a prolonged period of time, be sure the robot will not be exposed to condensation.
Unless otherwise specified, desiccant is not placed in the carton when shipped. If the robot is to be
stored/preserved in an environment subject to condensation, provide preventive measures from over the
carton or directly to the robot after unpacking.
The maximum storage/preservation temperature is 60
qC for a short storage period. If the robot is to be
stored/preserved for more than a month, the temperature should not exceed 50 qC.
250 mm (reference)