IAI America RCP3-RA2BR - Manual (Page 15)

9
5. Transportation
5.1 Handling a Single Actuator
Please adhere to the following when handling a single actuator.
5.1.1 Handling the Packed Unit
Unless otherwise specified, the actuator is shipped with each axis packaged separately.
Do not damage or drop. The package is not applied with any special treatment that enables it to
resist an impact caused by a drop or crash.
Transport a heavy package with at least more than two operators. Consider an appropriate
5.1.2 Handling the Actuator After Unpacking
Be careful not to bump the actuator into anything when moving it.
Do not apply an excessive force to each part of the actuator. In particular, prevent the motor unit
and rear bracket from receiving an unnecessary force.
Supplement) For the names of each part of the actuator, refer to 1, "Part Names".
method for transportation.
Keep the unit in horizontal orientation when placing it on the ground or transporting. Follow the
instruction if there is any for the packaging condition.
Do not step or sit on the package.
Do not put any load that may cause a deformation or breakage of the package.
Do not carry an actuator by a cable or attempt to move it by pulling the cable.
Hold the body base when transporting the actuator.