Gilderfluke&Co BR-ANA Analog Output Smart/Dumb Brick - Manual (Page 58)

8) Select Show Commands:
“)” (card address) (show#)!! ! Select Show Track:
! “*” (show#)! ! ! ! ! ! ! ! Select Show Global:
Up to two hundred fifty-five different animated shows can be stored on a
single Br-ANA. These commands can be used to select an individual show
on the selected Br-ANA(s). Individual shows can be requested with a range
of 01 to FFH. Once a show is selected, it will be played on the next serial
port START or LOOP command.
If a show selection has been made inadvertently, it can be cleared by
sending a request for show number 00.
9) Show Pause Commands:
“<” (card address)!! ! ! ! ! Pause Show:
! “>” (card address)!! ! ! ! ! Continue Show:
Any show can be paused at any point during its playback. The outputs
are frozen at the ʻlevels they were at the instant the PAUSE command is re-
ceived.
The CONTINUE command will resume any show playing which has pre-
viously been PAUSED.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Br-ANA Manual / December 18, 2012 10:21 AM / page 58 of 60