Gilderfluke&Co BR-ANA Analog Output Smart/Dumb Brick - Manual (Page 48)

A) not used:
This is the default setting for all inputs. Leave any unused inputs as ʻnot
usedʼ
B) Start Show:
This is the most commonly used trigger input command. It tells the Br-
ANA to start the selected show with the ʻloopingʼ flag set. On the LCD dis-
play and Br-ANAʼs menus, the show status will be shown as ʻloopingʼ, to in-
dicate that the show will check the ʻat endʼ actions that have been set for the
show when it completes playing.
Use the drop down to the right of the Input Action to select whether this
Input Action will start playing ʻwhatever is nextʼ in the AutoDownload list of
shows, or a specific show. All the shows in the AutoDownload list will be
shown in the drop down, and you can select the specific one you would like
to start.
C) Stop Show:
This tells the Br-ANA to stop playing a show on a sequencer immediately.
The show is frozen at the current frame, as are the analog and digital out-
puts. On the LCD display and Br-ANAʼs menus, the show status will be
shown as ʻSTOPPEDʼ, to indicate that the show was not allowed to play to
completion. On starting another show on this sequencer, all the analogs will
be EasedIn to the new show.
D) Stop At End:
This is the Input Action you use when you want to stop a show which is
playing on a sequencer, but allow it to play through to its natural end. On the
LCD display and Br-ANAʼs menus, the show status will be shown as ʻplay-
ingʼ, to indicate that the show will NOT check the ʻat endʼ actions that have
been set for the show.
E) Pause Show:
This pauses the show playing on the selected sequencer immediately.
The analog and digital outputs are frozen at their current states. On the LCD
display and Br-ANAʼs menus, the show status will be shown as ʻpausedʼ.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Br-ANA Manual / December 18, 2012 10:21 AM / page 48 of 60