Gilderfluke&Co BR-ANA Analog Output Smart/Dumb Brick - Manual (Page 21)

There are four optically isolated digital inputs which can be used to start,
stop, pause or select specific show sequences to play. Facing the end of the
wire, with the latch upwards, the pinout of a standard ʻJ8ʼ cable is as follows:
POSITION WIRE # COLOR SIGNAL NAME:
LEFT
RIGHT
1 white Input ʻDʼ
2 black Common
3 red Input ʻBʼ
4 green Input ʻBʼ
5 yellow Status Out
6 blue Input ʻCʼ
Any event can be triggered on either the ʻclosingʼ or ʻopeningʼ edge of any
input. A ʻclosingʼ is when a current starts flowing out of an input. An ʻopeningʼ
is when that current stops. The inputs can be triggered on any voltage from
5 to 24 VDC. Although a battery is shown in the following drawing, you can
use any type of power supply.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Br-ANA Manual / December 18, 2012 10:21 AM / page 21 of 60