Strike installation – Securitron M380BD_C_C2_X MAGNALOCK_Series User Manual
Page 12
PN# 500-23310
Page 12
Rev. B 06/14
Strike Installation
1.
Close the door and place the template between the bracket spacers.
Mark the strike plate hole locations.
Bracket spacers can now be removed from the bracket.
2. From INSIDE the door:
Drill one (1) 3/8” diameter hole for the
sex bolt through the door at the strike
mounting center mark.
Drill two (2) 3/8” diameter x 1” deep
holes at each side mark for the strike
alignment roll pins. Do not drill through
the door.
3. From OUTSIDE the door:
For a Hollow Metal Door: Drill out the 3/8”
diameter strike mounting hole to 1/2”
diameter in the outer wall only.
For a Solid Wood Door: Drill out 3/8”
diameter strike mounting hole to 1/2”
diameter; drill completely through.
Quick Clip 5:
Door
Drilling
Quick Clip 4:
Strike
Installation
Bracket Spacers
- ASB_Series (2 pages)
- ASCWB-DM62CL (4 pages)
- CWB_Series (2 pages)
- EASB_Series (4 pages)
- GDB (2 pages)
- HHD (6 pages)
- IK_Series (3 pages)
- M34R_Series (10 pages)
- M370 (16 pages)
- M38 (L, S and LS with D and T Options) (14 pages)
- M38 T UPGRADE (2 pages)
- M670 (16 pages)
- M680BDCX (16 pages)
- M32 (16 pages)
- Z-32 (2 pages)
- ZA-32 (3 pages)
- UHB (2 pages)
- TJ-38 (7 pages)
- TDK-1 (1 page)
- SWB-03 (2 pages)
- SMLS_SMSS (4 pages)
- SAM2C-24 (1 page)
- SAM2-24 (11 pages)
- SAM (16 pages)
- 32 REPLACEMENT STRIKE (1 page)
- UNL-12 UNLATCH (10 pages)
- STK-1 (2 pages)
- MUNL-12 (11 pages)
- MM15-TS (1 page)
- MM15 Z-Bracket_Series (1 page)
- MM15 (2 pages)
- Blind Nut (1 page)
- FSUNL_Series (2 pages)
- SCL-12 (4 pages)
- MCL-24 (8 pages)
- SWK (2 pages)
- SPK (2 pages)
- SASM KIT STRIKE (1 page)
- GL1 Quick Start (1 page)
- GL1 Install (10 pages)
- FMK-SW (7 pages)
- BPSS-10 (7 pages)
- PB5E (2 pages)
- PB5 (2 pages)