Final wiring – Securitron M680BDCX User Manual
Page 14
PN# 500-10560
Page 14
Rev. D, 07/12
Final Wiring
1.
Pull wires/cables through the wire feed-through hole(s) that are drilled in the frame. A small
screwdriver has been included to help make connections to the terminal blocks as required.
The end user and installer are liable for Fire and Building code compliance.
2.
The following diagram shows a basic wiring configuration for the Magnalock.
M680BDCX
3.
Motion Detector models: Enable the motion detector by locating DIP Switch SW2, and setting
Switch 5 to ON. REX timer is set with Switch 3. OFF= 5 seconds, ON= 10 seconds
Camera Models: Connect the camera to your security system using the included BNC cable.
See also other documents in the category Securitron For Home:
- ASB_Series (2 pages)
- ASCWB-DM62CL (4 pages)
- CWB_Series (2 pages)
- EASB_Series (4 pages)
- GDB (2 pages)
- HHD (6 pages)
- IK_Series (3 pages)
- M34R_Series (10 pages)
- M370 (16 pages)
- M38 (L, S and LS with D and T Options) (14 pages)
- M38 T UPGRADE (2 pages)
- M380BD_C_C2_X MAGNALOCK_Series (20 pages)
- M670 (16 pages)
- M32 (16 pages)
- Z-32 (2 pages)
- ZA-32 (3 pages)
- UHB (2 pages)
- TJ-38 (7 pages)
- TDK-1 (1 page)
- SWB-03 (2 pages)
- SMLS_SMSS (4 pages)
- SAM2C-24 (1 page)
- SAM2-24 (11 pages)
- SAM (16 pages)
- 32 REPLACEMENT STRIKE (1 page)
- UNL-12 UNLATCH (10 pages)
- STK-1 (2 pages)
- MUNL-12 (11 pages)
- MM15-TS (1 page)
- MM15 Z-Bracket_Series (1 page)
- MM15 (2 pages)
- Blind Nut (1 page)
- FSUNL_Series (2 pages)
- SCL-12 (4 pages)
- MCL-24 (8 pages)
- SWK (2 pages)
- SPK (2 pages)
- SASM KIT STRIKE (1 page)
- GL1 Quick Start (1 page)
- GL1 Install (10 pages)
- FMK-SW (7 pages)
- BPSS-10 (7 pages)
- PB5E (2 pages)
- PB5 (2 pages)