Securitron M680BDCX - Manual (Page 10)

PN# 500-10560
Page 10 Rev. D, 07/12
4. Install Roll Pins into Strike Plate:
Remove the two (2) roll pins from the hardware packet.
Insert a roll pin into each of the holes in back of strike. Gently tap into place using a hammer
.
5. Secure Strike Plate to the Door
Apply the included threadlock compound to the 5/16-18 X 1-3/4” flat head socket screw.
Pass the 5/16-18 X 1-3/4” flat head socket screw through the strike plate, two (2) neoprene
washers, door and into the sexbolt as illustrated.
Use a 3/16” hex wrench to tighten the screw into the sex bolt. (While tightening, use a hammer to gently tap
the head of the sex bolt until the head sits flush with the door).
Not Do NOT over-tighten the assembly, the neoprene washers should not be compressed.
Allow the strike to rock on the neoprene washers for proper function and optimum holding force.
Sex Bolt
Strike
(2) Neoprene
Washers
5/16-18 X 1-3/4”
Flat Head Socket
Screw
Quick Clip 6:
Mounting
Strike Plate