Rivers Edge RE607 22' Timbershot - Manual (Page 19)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 19
Operator's Manual
Rivers Edge® One-Man Ladder Stands
10. a. Using a rubber mallet, gently tap in (2) plastic pipe plugs (48869)
into the short side of the armrest tubes.
b. Attach the armrests (410009) to the seat upright weldments us-
ing (2) provided 1/4-20 x 2-1/4” bolts, locknuts, steel washers and
nylon washers. sEE fIGuRE 7. Nylon washers should be placed
between armrests and seat upright weldments.
c. Attach the loose end of the (2) armrest straps (410103) to the
armrest using (2) provided (2) 1/4-20 x 1-1/2” bolts, locknuts and (4)
steel washers. sEE fIGuRE 7. Bolts must go through two holes on
armrest straps. Armrest straps must wrap around bottom of arm-
rests.
11. a. Insert the (2) curtain rail uprights (410019) into the curtain rail
J-pipes and secure together using (2) provided 1/4-20 x 1-1/4” bolts,
locknuts and steel washers. sEE fIGuRE 8.
b. Attach the (2) curtain rail uprights to the rear platform us-
ing (2) provided 1/4-20 x 2” bolts, locknuts and steel washers.
sEE fIGuRE 8.
12. a. Attach the bottom of the mesh backrest (360007) and the seat
retainer bar (410010) to the rear of the welded seat frame using (3)
provided 1/4-20 x 1-1/2” bolts, locknuts and steel washers. sEE fIG-
uRE 9a and 9b on following page. The mesh backrest must wrap
around the front, bottom, and back side of the seat frame tube; the
plastic stiffening rod located in the sewn sleeve of mesh backrest
MUST be positioned above the seat retainer bar to act as a stop and
prevent the backrest from pulling out during use. All bolts MUST go
through the seat retainer bars, both sets of holes provided in the
mesh backrest and the seat frame tube. Tighten these three bolts
securely at this time. Do not crush tubing when tightening!
Figure 8
Figure 7
1/4-20 x
2-1/4" bolts
armrests
steel washers
locknuts
seat upright
weldments
curtain rail
uprights
curtain rail
J-pipes
1/4-20 x
1-1/4" bolts
steel washers
locknuts
1/4-20 x 2" bolts
steelwashers
locknuts
nylon washers
armrests straps