Reese 50024 TITAN ROUND TUBE SLIDER - Manual (Page 5)

50024N Ŕ 7/5/11 F PCN12170 ©2011 CEQUENT PERFORMANCE PRODUCTS, INC. Printed in XXX
5
5. Loosely assemble head support to REESE
™
FIFTH Wheel
Slider at desired height.
NOTE: Bottom position may not be used on all
hitch models. Use the cotter pin(4) and indicator pin(6) to trap handle(3) in
place as shown. Be sure pin is installed in handle as shown. Install so that
the indicator pin goes through the bottom side of the latch casting and is in the
slot of the casting. (See Figure 11).
Figure 13
7. Coat top surface of slide tube and roller holes in each
slider assembly with all purpose grease or Teflon lube, use
as needed (see Figure 12). Repeat this application monthly
during use.
Figure 12
Figure 10
6. Snug up all bolts and nuts.
Torque
1/2” bolts to 85 ft. lb.
Cotter pin (4).
On back inside.
Indicator pin (6)
ROLLER
SLIDE TUBE
LOCK WASHER
& BOLT
END CAP
LEAF SPRING
LATCH
WELD ON FOOT
BOLT ON FOOT
Indicator pin (6) below latch casting.
Figure 11
Cotter pin (4)
On back side
ROLLERS
SLIDE TUBE
WARNING:
Slide hitches that are not properly locked can suddenly move and kill you!
To avoid death or serious injury:
•Never place any part of your body in the truck bed or between the truck and the trailer
unless each and every one of the following conditions are met :
1. Truck is in park with emergency brake on, and
2. All trailer wheels are blocked on each side of wheel.
•Always perform “push test” or “pull test” by following the instructions in this manual.