Reese 37069 MULTI-FIT RECEIVER - Manual (Page 5)

TOOLS REQUIRED
1/2” CARRAIGE BOLT
3/8” BOLT
1/2” DRILL BIT
9/16” SOCKET
9/16” WRENCH
3/4” SOCKET
3/4” WRENCH
TORQUE WRENCH
SAFETY GLASSES
1/2” HEX BOLT
1/4” BOLT PLATE
1/2” CONICAL WASHER
1/2” NUT
3/8” FLANGE NUT
FRONT
REAR
PICTURE ABOVE DOES NOT SHOW INNER MOUNTING BRACKET ON CROSS TUBE FOR CLARITY - SHOWN ON PAGE 9
2000-2005 TOYOTA TUNDRA :
1. Use existing hole at the rear of the frame and install the 1/2” bolts through the bolt plates and into the frame. With the 1/2” conical washer
and 1/2” nut, bolt the brackets to the frame. Leave the bolts loose enough to center bracket on frame of truck. Do not install fasteners in the
forward hole in the brackets at this time.
2. Install the center section to the brackets as shown. Use the bolting location indicated. Install 3/8” bolts through the center section
and the bracket as shown. Install 3/8” flange nuts on the bolts.
3. Using the forward most holes in the brackets as a guide drill a 1/2” hole and install the 1/2” bolts with 1/4” bolt plates through the
frame and brackets. Then install the 1/2” conical washers and 1/2” nuts.
NOTE: Be sure to use four holes to bolt the brackets to the center section.
4. Tighten the nuts in the following order:
First torque the 3/8" nuts to 35 ft•lb.
Then torque the 1/2" nuts to 70 ft•lb.
NOTE: SIDE BRACKETS MAY DEFLECT WHEN TIGHTENED
5