FEC AFC1500 - Manual (Page 60)

Output signals from the SAN Servo Controllers
The output signals listed below are signals available from the individual
spindle controller (SAN) Unit and only indicate status from that particular
spindle. They do not indicate status from any other spindle or group of
spindles. These are typically used for individual spindle status display.
The number in the tables below are only for reference showing total number of
signals available per spindle. (Total number of available signals from the SAN
Units: 31 Spindles X 28 Signals = 868 signals)
Current Warning High AMP HI 28
Current Warning Low AMP LO 27
Torque Rate 3 High Reject TR3 HI 26
Torque Rate 3 Low Reject TR3 LO 25
Torque Rate 2 High Reject TR2 HI 24
Torque Rate 2 Low Reject TR2 LO 23
Torque Rate 1 High Reject TR1 HI 22
Torque Rate 1 Low Reject TR1 LO 21
Angle High Reject AN HI 20
Angle Low Reject AN LO 19
Peak Torque High Reject PT HI 18
Peak Torque Low Reject PT LO 17
Final Torque High Reject FT HI 16
Final Torque Low Reject FT LO 15
Time 2 Reject High TM2 HI 14
Time 2 Reject Low TM2 LO 13
Time 1 Reject High TM1 HI 12
Time 1 Reject Low TM1 LO 11
Parameter Select 4 bit P SEL 4 10
Parameter Select 3 bit P SEL 3 9
Parameter Select 2 bit P SEL 2 8
Parameter Select 1 bit P SEL 1 7
Busy BUSY 6
Ready RDY 5
In Bypass BYP 4
Abnormal ABN 3
Accept ACC 2
Reject REJ 1
AFC1500 SAN Servo Controller Output Signals
Chapter 4: I/O & Output Data
60