Teledyne GC-Pro/TCD - Gas Chromatograph - Manual (Page 18)

Introduction GC-Pro TCD
Teledyne Analytical Instruments 4
Figure 1-1: GC-Pro TCD Front Panel
Gas pressure gauges and controls are mounted on the front panel
adjacent to the touch screen (human/machine interface abbreviated as
HMI) display as shown in Figure 1-1.
At the rear of the instrument are ports for the introduction of air,
zero, span, and sample gas as well as vent port connections. Three 50-
pin user-interface cable connectors route input/output and alarm signals
to external devices. RS232 and a network port are also available at the
rear panel for connection to a remote computer or other digital
communication device. Internally, there are two USB user connections
which are used for updating firmware to the PCBs. Figure 1-2 shows the
rear panel including the user connections.
The analyzer is set up for either 120 VAC 60 Hz or 230 50/60 Hz
operation depending on the customer’s requirements. The appropriate
power cord for your unit is included with the analyzer.