Teledyne GC-Pro/FID - Gas Chromatograph - Manual (Page 10)

GC-Pro FID
Teledyne Analytical Instruments x
3.3 User Connections 16
3.3.1 Electrical Power Connections 16
3.3.2 Electronic Connections 16
3.3.2.1 Primary Input Power 17
3.3.2.2 Fuse Installation 18
3.3.2.3 50-Pin Equipment Interface Connector 18
3.3.2.4 Analog Output 18
3.3.2.5 Alarm Relays 20
3.3.2.6 Digital Remote Cal Inputs 22
3.3.2.7 ‘Measure Once’ (or one shot measurement)
contacts 23
3.3.2.9 Pin Out Table 23
3.3.2.10 RS-232 Port 26
3.3.3 Gas Connections 27
3.3.3.1 Effluent 29
3.3.3.2 Sample Bypass Vent 29
3.3.3.3 Fuel and Air Connections 30
3.3.3.4 Sample and Span Gas Connections 30
3.4 Placing the System in Operation 30
Operation ..................................................................................... 31
4.1 Equipment 32
4.2 Preliminary Power-Off Check List 33
4.3 Powering Up the Unit 33
4.4 Activating the Support Gases 35
4.4.1 Air 35
4.4.2 Carrier Gas 36
4.4.3 Span Gas 36
4.4.4 Fuel 36
4.5 Sample Pump 36
4.6 Flame Ignition 36