Teledyne 3000TA-XLEU - Trace oxygen analyzer - Manual (Page 79)

Trace Oxygen Analyzer Web Implementation
Teledyne Analytical Instruments 63
Web Implementation
5.1 The Embedded Browser
The 3000TA-XL-I series instruments come with an Ethernet Web
Enabled co-processor. This means that all you need is an Ethernet
connection to access the analyzer remotely through an internet browser
such as Microsoft
® Explorer.
The following three steps will web enable your instrument:
1. Follow the instructions in Chapter 4 Section 4.10 to set the IP
address from the front panel of the 3000TA-XL-EU-I Trace
Oxygen Analyzer.
2. Connect the analyzer to a network through the RJ45
connector on the side of the instrument.
3. Now you can access the analyzer through an internet browser
by typing the IP address of the 3000TA-XL-EU-I analyzer.
The address might look like this:
http://192.168.1.250
where the numbers are changed to match the numbers entered
into the 3000 analyzer. Your browser should display a web
page that looks similar to Figure 5-1. The browser data should
update approximately every two seconds.
Figure 5-1 shows the opening window that displays once the IP
address is entered into the browser window. There are three main areas
on the screen as shown in the figure:
 Buttons
 Message Window
 Analyzer Data