Teledyne 2020 - Explosion proof thermal conductivity analyzer - Manual (Page 42)

4 Operation Model 2020
4-8 Teledyne Analytical Instruments
Use the UP/DOWN key to scroll the blinking over to
PSWD
, and press
Enter to select the password function. Either the default
TAI password or
AAA place holders for an existing password will appear on screen depending
on whether or not a password has been previously installed.
Enter password:
T A I
or
Enter password:
A A A
The screen prompts you to enter the current password. If you are not
using password protection, press Enter to accept TAI as the default pass-
word. If a password has been previously installed, enter the password using
the ENTER key to scroll through the letters, and the UP/DOWN key to
change the letters to the proper password. The last ENTER enters the
password.
In a few seconds, you will be given the opportunity to change this
password or keep it and go on.
Change Password?
=Yes =No
Press Escape to move on, or proceed as in Changing the Password,
below.
4.3.3.2 Installing or Changing the Password
If you want to install a password, or change an existing password,
proceed as above in Entering the Password. When you are given the oppor-
tunity to change the password:
Change Password?
=Yes =No
Enter to change the password (either the default
TAI or the previously
assigned password), or press Escape to keep the existing password and
move on.
If you chose Enter to change the password, the password assignment
screen appears.
Select new password
T A I
or