Teledyne 2010A - Split architecture thermal conductivity analyzer - Manual (Page 10)

Teledyne Analytical Instruments 1- Part
1 Introduction
Model 2010A
1.2 Typical Applications
A few typical applications of the Model 2010A are:
• Power generation
• Air liquefaction
• Chemical reaction monitoring
• Steel manufacturing and heat treating
• Petrochemical process control
• Quality assurance
• Refrigeration and storage
• Gas proportioning control.
1.3 Main Features of the Analyzer
The main features of the Model 2010A Thermal Conductivity Ana-
lyzer include:
• Three independent, user definable, analysis ranges allow up to
three different gas applications with one concentration range
each, or up to three concentration ranges for a single gas appli-
cation, or any combination.
• Special recalibration range for multiple applications. Recalibrat-
ing one, recalibrates all.
• Automatic, independent linearization for each range.
• Auto Ranging allows analyzer to automatically select the proper
preset range for a given single application. Manual override al-
lows the user to lock onto a specific range of interest.
• RS-232 serial digital port for use with a computer or other digi-
tal communications device.
• Six adjustable concentration set points with two alarms and a
system failure alarm relay.
• Extensive self-diagnostic testing, at startup and on demand.
• A 2-line alphanumeric display screen, driven by microprocessor
electronics, that continuously prompts and informs the operator.
• High resolution, accurate indication of target or impurity gas
concentration from large, bright, meter readout. (0-9999 ppm
through 0-100 % depending on types of gas involved.)
• Standard, proven sensor cell design.
• Wide range of custom applications, ranges, and linearization.