Liquid Controls SP2800 User Manual

Page 25

3-10 Setup Procedure For The Batcher (continued)

MENU ITEM 7 OUTCARD
If the unit is equipped with a serial communications card, the setup parameters in the following
menu will make the Batcher compatible with the master terminal. The Unit Identification
Number (if multiple units are used), Baud Rate (speed at which the signal is transmitted) and
Parity are selectable. A 7 bit, ASCII character, with one start bit, one stop bit and the parity
makes up the standard ten bit transmission character. For more details see Section 8.

PRESS

DISPLAY

PRESET

↓↓↓↓↓

PREWARN

↓↓↓↓↓

DEV TYP

↓↓↓↓↓

LOCKOUT

↓↓↓↓↓

OUTCARD

↓↓↓↓↓

UNIT ##

The Unit ID Number identifies the unit for multi-drop communications. Up to 15
units may be on one line. A unit will stay off line until its Unit ID number is received. It
will then stay on line until a carriage return is sent. At which time, it will send any
requested information and take itself off line. The range of the unit ID number is 00 to
15

NOTE:

A Unit ID number of 00 will keep the unit on line at all times. No Unit
Number prompt is needed and carriage returns will not take the unit off
line.

Regardless of the above, all requests for information are replied to at the units earliest
convenience.

UNIT 00

Clears out existing Unit ID number.

UNIT 12

Sample Unit ID number.

↓↓↓↓↓

SER

↓↓↓↓↓

Enters new Unit ID number.

Chooses SER (PL not available)

BAUDRATE

BAUDRATE flashes then shows current Baud rate.

Continued on next page.

ENT

CLR

ENT