3 sata/sas backplane – Asus Pedestal/5U Rackmount Server TS500-E4 Server User Manual
Page 58
Chapter 2: Hardware setup
2-36
2.10.3 SATA/SAS backplane
To remove the SATA/SAS backplane:
1. Remove the HDD blower case. Refer to section “2.10.2 HDD blowers”
for instructions.
2. Disconnect all cables from the
SATA/SAS backplane.
When disconnecting a cable,
hold and firmly pull the cable
plug. DO NOT pull the cable
itself. Doing so may damage
the cable!
3. From the inner edge, push the
backplane outward so that the
outer edge protrudes slightly from
the slot.
4. From the outer edge, firmly hold
the backplane and carefully slide it
out.
This manual is related to the following products: