Asus Pedestal/5U Rackmount Server TS500-E4 Server - Manual (Page 10)

x
About this guide
Audience
This user guide is intended for system integrators and experienced users
with at least basic knowledge of configuring a server.
Contents
This guide contains the following parts:
1. Chapter 1: Product Introduction
This chapter describes the general features of the server, including
sections on front panel and rear panel specifications.
2. Chapter 2: Hardware setup
This chapter lists the hardware setup procedures that you have to
perform when installing or removing system components.
3. Chapter 3: Installation options
This chapter describes how to install optional components into the
barebone server.
4. Chapter 4: Motherboard information
This chapter gives information about the motherboard that comes
with the server. This chapter includes the motherboard layout, jumper
settings, and connector locations.
5. Chapter 5: BIOS information
This chapter tells how to change system settings through the BIOS
Setup menus and describes the BIOS parameters.
6. Chapter 6: RAID configuration
This chapter provides information on how toconfigure your hard disk
drives as RAID sets.
7. Chapter 7: Driver installation
This chapter provides information on how to create a RAID set and
how to install the drivers for system components. This chapter also
describes the software applications that the barebone server supports.
8. Appendix: Reference information
This section provides information about the power supply unit and a
troubleshooting guide for solving common problems when using the
barebone server.