Asus Pedestal/5U Rackmount Server TS500-E4 Server - Manual (Page 120)

5-26 Chapter 5: BIOS information
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit →← Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Configure serial port A
using option:
[Disabled]
No configuration
[Enabled]
User configuration
[Auto]
BIOS or OS chooses
configuration
[OS Controlled]
Displayed when
controlled OS
Peripheral Devices Configuration
COM1 Port: [Enabled]
Base I/O address: [378]
Interrupt: [IRQ 4]
COM2 Port: [Enabled]
Mode: [Normal]
Base I/O address: [2F8]
Interrupt: [IRQ 3]
Parallel port: [Enabled]
Base I/O address: [378]
Interrupt: [IRQ 7]
Mode: [ECP]
DMA channel [DMA 3]
Floppy disk controller [Enabled]
PhoenixBIOS Setup Utility
Advanced
5.4.5 Peripheral Devices Configuration
This menu shows the peripheral devices configuration settings. Select an
item then press to display the configuration options.
COM1 Port [Enabled]
Allows you to configure serial port A. Configuration options: [Disabled]
[Enabled] [Auto]
Base I/O address [3F8]
Allows you to select the base I/O address for serial port A. Configuration
options: [3F8] [2F8] [3E8] [2E8]
Interrupt [IRQ 4]
Allows you to set the interrupt for serial port A. Configuration options: [IRQ
3] [IRQ 4]
COM2 Port [Enabled]
Allows you to configure serial port B. Configuration options: [Disabled]
[Enabled] [Auto]
Mode [Normal]
Allows you to set the mode for serial port B. Configuration options: [Normal]
[IR] [ASK-IR]
Base I/O address [2F8]
Allows you to select the base I/O address for serial port B. Configuration
options: [3F8] [2F8] [3E8] [2E8]