Controlled Products Systems Group 1601-080 - Manual (Page 35)

1601-065-M-05-07 36 installation guide
technical information/accessories
The following accessories are available for 1601 operators.
Loop Detector
/plug directly into ports on circuit board simplifying wiring.
P/N 9406-010 - Single channel detector.
P/N 9405-010 - Two channel detector.
Loop Wire
/with XLPE insulation is available in 500 and 1000 foot rolls, available in Black, Blue and Red insulation.
Loop Sealant
P/N 2600-771 Asphalt
P/N 2600-772 Concrete
Meg Ohm Meter
/checks the integrity of ground loops.
P/N 9401-045
Reverse Edge
/installs on the bottom of the wood arm.
P/N 8080-016
Photo Cell
/prevents arm from lowering on vehicles or pedestrians.
P/N 8080-018
Time Clock
/7 and 365 day clocks, used to automatically open gate at pre-set time, fits inside operator.
P/N 2600-791 7 day clock
P/N 2600-795 365 day clock
Surge Devices
/helps prevent circuit board failure caused by lightning strikes and power surges.
P/N 1876-010 - High Voltage
P/N 1878-010 - Low Voltage
Replacement Batteries
/back-up system.
P/N 1801-009
Speed Bumps
/prefabricated 6-foot speed bump reduces traffic speed through gate system.
P/N 1610-150
Heater Kit
/thermostatically controlled heater for cold weather areas.
P/N 1601-092
Fan Kit
/thermostatically controlled fan for hot humid environments.
P/N 1601-093
Gate Tracker™
/optional control board allows the barrier gate operator to report activity to a
companion 1833, 1835, 1837 or 1838 access control system.
Wood Arm
/14-foot replacement wood arm.
P/N 1601-048
Aluminum Arm
/14-foot replacement aluminum arm.
P/N 1601-216
Arm Padding
/foam padding for the aluminum or wood arm.
P/N 1601-211
Shaft Spacer
/used when attaching additional spike assemblies.
P/N 1601-069