Controlled Products Systems Group 1601-080 - Manual (Page 20)

1601-065-M-05-07 installation guide 21
arm installation/hub
Using the supplied hardware install and
secure the arm hub as shown.
(2) Hex Bolt
(1) Mounting Hub
(3) Locking Plate
(4)Screw
1
1
Follow the same instructions when in-
stalling an additional mounting hub on
the opposite side.
2
2
Test operator and set the up
and down direction before
installing arm.
Install the arm hub with the
mounting holes in a X pattern
when the operator is in the
down position.