Kolpin 10-0520 X-Factor Plow User Manual

Page 17

OPTION C - MOUNT INSTALLATION: POLARIS 400/500/800 H.O. ATVs

1. Position the Forward Mount Weldment, Item #1, under the frame tubes at the “Y” location as shown in Illustration 12.

2. IMPORTANT: To keep the mount level and clear the built-in rock guard extrusion on Sportsman HO ATVs, add spacers, Item #8 to

the forward channel of the mount. Loosely fasten the spacers between the mount and rock guard with bolts, washers and locknuts,
Items #9, #5 and #6. Do not torque fasteners at this time. See Illustration 12.

3. Position the Back Plate, Item #2, on top of the frame tubes at the “Y” location as shown in Illustration 12.

4. Place spacers, Item #7, between the mount and back plate. Loosely fasten the mount and back plate using bolts, washers and

locknuts, Items #3, #5 and #6. Do not torque fasteners at this time.

5. Once the mount has been positioned, orientate fasteners, Item #3, to the frame tube walls as close as possible and torque to

specification. REFER TO INSTALLATION NOTES - PAGE 5.

FASTENER TORQUE:

30 ft. lbs. (41 Nm)

ILL. 3

ATV FRONT

ROCK GUARD

POLARIS H.O. FRAME SECTION