Step 3 - attach plow blade to the push tube, Notice – Kolpin 10-0520 X-Factor Plow User Manual

Page 13

STEP 3 - ATTACH PLOW BLADE TO
THE PUSH TUBE:

1. Place the assembled push tube onto plow frame of

the assembled blade. Place bushings, Item #5 into
the plow frame supports as shown in Illustration 12.
Place 2 washers, Item #16 over the holes and fasten
the push tube to the blade assembly using carriage
bolts, Item #14 and locknuts, Item #15. See
Illustration 12. Torque fasteners to specification.

2. Install the blade stops, Item #19. Fasten with nuts,

Item #18. See Illustration 13. Do not torque the
fasteners at this time.

3. Assemble blade springs, Item #26, and eyebolts, Item

#25 between the blade assembly and spring brackets
as shown in Illustration 13. Fasten and adjust tension
with washers, Item # 23 and nuts, Item #24.

Item #14 - FASTENER TORQUE:

50ft. lbs. (67.7 Nm)

NOTICE

BLADE TILT / STOP ADJUSMENT:

Perform with plow system mounted

and in the down position.

Blade position should be vertical for best performance

ILL. 13

Optional Blade Stop Locations

ILL. 12

NOTICE

INITIAL BLADE SPRING TENSION:

Refer to Installation Notes on Page 8

ILL. 14