Kolpin 2691 – Ranger 800cc Crossover Tool Box - Manual

Rev.
1
2690/2691
–
Ranger
400cc/800cc
Crossover
Tool
Box
No.
Description
QTY.
Spare
P/N
1
Crossover
Tool
Box
1
2
Metal
Adaptor
Plates
2
120065-­‐400CC,
120070-­‐800CC
3
KXP
Expansion
Plungers
4
98510
4
5/16”
x
1.00
Truss
Head
Bolts
8
6
5/16”
Washers
8
7
5/16”
Nylon
Nuts
8
Mounting Instructions – (NOTE: 400 cc and 800cc models have different mounting plates! 400cc models
use 3 90 degree bends and the KXP plungers mount in the rail edge with TWO holes)
1. Attach the (2) KXP Expansion Plungers to the Metal Adaptor Plate (800cc model shown). Snug the
handles only, if compressed too much the Expansion Plungers will not fit in the bed rail.
2. Place both brackets into the bed rail at your desired location and tighten the plungers.
3. Set the box on top of the brackets and mark mounting hole locations with a marker. These points
will be drilled for the 5/16” Hardware. Loosen KXP plungers, remove the plate and drill the box.
4. Secure the box to the bracket using the hardware provided. Install the truss head bolts through the
bracket and secure with the large flat washers and nylon nuts on the INSIDE of the box