Kolpin 98010 – Heated Throttle Master - Manual

Rev. 1
Kolpin Outdoors, Inc., 205 N. Depot Street, Fox Lake, WI Phone #: (877) 9KOLPIN or (920) 928-3118 www.kolpin.com [email protected]
98010 – Heated Throttle Master
Mounting Instructions:
1. Place the Heated Throttle Master over your existing throttle on your ATV.
2. Place the ¼” Truss Head Bolts through the holes in mounting base. Tighten enough to hold the Heated Throttle
Master on your throttle lever..
3. Check the location of your new Heated Throttle Master. You can slide the actual lever portion outwards from the
attachment base to obtain more leverage.
4. Once proper location is achieved tighten down the mounting base securely to the OEM throttle lever.
5. Place the Rubber Caps over the extra threads that protrude out past the backside of the Mounting Base.
**Warning** - With the machine off, check the operation of your throttle! It must open and close
with no interference from the grip!! You may have to cut your handle bar grips to insure proper
operation! Failure to check this could cause your throttle to not return to the idle position and could
result in serious injury or death!
NO. DESCRIPTION QTY.
1 MOUNTING BASE 1
2 HEATED THROTTLE MASTER 1
3 ¼” TRUSS HEAD BOLT 2
4 ¼” LOCK NUT 2
5 RUBBER CAP 2
Interference – Trim with
knife or scissors!