INTELLINET NETWORK NSC18-WN User Manual - Manual (Page 30)

30
WEB MANAGEMENT INTERFACE
Sending File Type — Select the file type that’ll be saved when motion
is detected. Select “JPeG” and a still picture in JPeG format will be
saved; select “AVI” to save a video clip.
Send snapshot file to FTP — Select “Enable” to send the saved file to
the designated FTP server when motion is detected; select “Disable”
to disable the function. NOTE:
You need to configure the FTP server
parameters first (see 3.5.4 FTP Configuration below).
Send snapshot file to E-Mail — Select “Enable” to send the saved file
to the designated e-mail address when motion is detected; select
“disable” to disable the function. NOTE:
You need to configure the
SMTP server
parameters first (see 3.5.3 E-Mail below).
Send snapshot file to SD Card — Select “enable” to send the saved
file to an inserted SD card when motion is detected; select “Disable”
to disable the function. (See 3.5.5 SD Card Configuration below.)
Apply — Click to put any of the above settings/changes into effect.
3.5.2 motion region
You can reduce the likelihood of a false alarm by defining the motion
detection region within the image captured by the camera. By doing so,
the camera will ignore motion outside the specified viewing region.
Region 1–3 — Select one, two or all three of the regions you want to
configure. As each region is selected, it will appear on the currently
captured image.
Sensitivity — Move the slide bar left or right to change the level of motion
detection sensitivity: left to decrease sensitivity (the camera will only
detect major changes in the image); right to increase sensitivity (the
camera will detect minor changes in the image). The level will display
as a percentage of maximum below each slide bar as it’s moved to
a new position.