INTELLINET NETWORK NSC18-WN User Manual User Manual

Page 10

Text mode
Original mode

SOFTWARE INSTALLATION

4. With the General
menu tab/screen
displayed, select
“Internet Protocol

(TCP/IP),” then
click “Properties.”

5. In the “IP address” field on the subsequent Properties screen, enter
an IP address beginning with “192.168.2” and ending with a value
between 2 and

254 (as shown).
In the “Subnet

mask” field, enter
“255.255.255.0.”
Click “oK.”

NOTE: If you forget
the IP address of the
camera after you
change it, there are
two ways to recover it:

• Reset back to

192.168.2.3 (and

lose all settings);

• Ask your network
administrator to
check the dHCP

release table (if
the camera was
set to obtain the
IP address by

DHCP).