Analog Way Orchestra2 - Manual (Page 38)

38
1. Press Edit Inputs to open the Inputs page.
2. Select Input 1 from the dropdown menu, and press the Matrix Map-
ping tab.
3. In the linked to Matrix dropdown line, select your Matrix.
4. Select Output 1 in the Matrix Output dropdown menu.
5. Repeat steps 2 & 3 for Inputs #2 to #4 (matrix outputs #2 to #4).
6. Press the OK button to return to the Screen Setup page.
So far, you have set a series of links between your slave device and a matrix, but you are still limited to the
slave device’s input switching (source 1 to slave device input #1, source #2 to slave device input #2 and so on).
To change this, proceed as follows:
1. Press Edit Sources to open the Source Setup page, and set the source
Type to Live.
2. In the Preview Source section, press source button 1 , and press Edit
if you wish to rename it.
3. In the Linked to Matrix dropdown menu, choose the matrix entered
previously, then the type of signal coming from the matrix.
4. In the Matrix Input dropdown menu, select the Matrix Input number
you like.
5. Repeat steps #2 to #4 for sources #2 to #8.
6.2 Matrix configuration