Climax VM1600 GATE VALVE GRINDING & LAPPING - Manual (Page 7)

Feb-10 / VM1350-1600 Gate Valve Grinding & Lapping Machine Brochure.doc Page 7 of 10
Accessories
P/N Description
240-13K-001 Maintenance unit for pneumatic motor
Required for machines with pneumatic motor.
The maintenance unit is not included in the standard scope
of supply with pneumatic driven machines.
Includes:
 filter
 oiler
 pressure
gauge
 speed
controller
440-52T-008 Setup adapter for flanges with threaded studs (2 pcs.)

Enables the set up of the machine without removing
the threaded studs of the flange.
 Are used instead of the clamping pads.

The tilting adapter is mounted 2.8”(70 mm) above the
flange.

The setup adapter can be screwed directly to the
threaded stud (bore diameter 1.0”(25 mm) and 0.7”(17
mm)) or clamped between the studs by the c-clamps
that belong to the scope of supply of the machine.
440-56S-N01 Fixture for gate wedges
For grinding of gate wedges “on site” with the VM machines.
440-00S-L03 Swing Check accessories
For grinding of swing check valves.
Includes:

swivel adapter for adaption of the machine on the valve

spindle extension for reaching the seat with the planet
wheels.