Atec Rohde-Schwarz-SMU200A - Manual (Page 43)

Version 08.00, January 2012
Rohde & Schwarz R&S ® SMU200A Vector Signal Generator 43
General data
Remote control
Systems IEC/IEEE bus, IEC 60625 (IEEE 488)
Ethernet
Command set SCPI 1999.5
Connector
IEC/IEEE 24-contact Amphenol
Ethernet Western
IEC/IEEE bus address 0 to 30
Interface functions IEC: SH1, AH1, T6, L4, SR1, RL1, PP1,
DC1, DT1, C0
Operating data
input voltage range, AC, nominal 100 V to 240 V
AC supply frequency 47 Hz to 63 Hz
input current 5.0 A to 1.6 A
Power supply
power factor correction in line with EN 61000-3-2
in line with EN 55011 class B, EN 61326 EMC
with activated digital I/Q output in line with EMC directive of
EU (2004/108/EC), applied standard:
EN 61326 (immunity for industrial
environment; class A emissions)
17
Immunity to interfering field strength up to 10 V/m
operating temperature range +5 °C to +45 °C,
in line with EN 60068-2-1, EN 60068-2-2
storage temperature range −20 °C to +60 °C
Environmental conditions
climatic resistance
+40 °C/90 % rel. humidity,
in line with EN 60068-2-3
Mechanical resistance
sinusoidal 5 Hz to 150 Hz, max. 2 g at 55 Hz,
55 Hz to 150 Hz, 0.5 g const.,
in line with EN 60068-2-6 Vibration
random 10 Hz to 300 Hz,
acceleration 1.2 g (RMS),
in line with EN 60068-2-64
Shock 40 g shock spectrum,
in line with EN 60068-2-27, MIL-STD-810E
Electrical safety in line with EN 61010-1
Dimensions W × H × D 435 mm × 192 mm × 460 mm
(17.1 in × 7.6 in × 18.1 in)
Weight if fully equipped 25 kg (55.1 lb)
Recommended calibration interval 3 years
License information
The firmware of this device contains open source software. Details and license agreements can be found in release notes and
operating manual.
17 The instrument complies with the emission requirements stipulated by EN 55011 class A. This means that the instrument is suitable for use in industrial
environments. In line with EN 61000-6-4, operation in residential, commercial and business areas or in small-size companies is not covered. The
instrument may not be operated in residential, commercial and business areas or in small-size companies, unless additional measures are taken to
ensure that EN 610000-6-3 is complied with.