Atec RohdeSchwarz-SMW200A - Manual (Page 6)

Version 01.02, September 2013
6 Rohde & Schwarz R&S ® SMW200A Vector Signal Generator
Frequency and baseband main module options
Frequency options
One of the following frequency options must be installed in RF path A:
R&S ® SMW-B103 100 kHz to 3 GHz
R&S ® SMW-B106 100 kHz to 6 GHz
In addition, one of the following frequency options can be installed in RF path B:
R&S ® SMW-B203 100 kHz to 3 GHz
R&S ® SMW-B206 100 kHz to 6 GHz
Signal routing and baseband main module options
One of the following options must be installed:
R&S ® SMW-B13 One I/Q path to RF section
R&S ® SMW-B13T Two I/Q paths to RF section
If RF path B is equipped (or is planned to be retrofitted) with an R&S ® SMW-B20x frequency option, an R&S ® SMW-B13T option must
be installed as the baseband main module.
Enhancement options
In addition to frequency options, the following RF enhancement hardware options can be installed (an R&S ® SMW-B13T option must
be installed as the baseband main module):
R&S ® SMW-B20 FM/ϕM modulator
R&S ® SMW-B22 Enhanced phase noise performance and FM/ϕM modulator
The following combinations of frequency and enhancement options are possible:
Configuration of RF path A Possible configurations of RF path B
R&S ® SMW-B103 or R&S ® SMW-B106 (path B not equipped)
R&S
® SMW-B203 or R&S ® SMW-B206
R&S ® SMW-B103 and R&S ® SMW-B20, or
R&S ® SMW-B106 and R&S ® SMW-B20
(path B not equipped)
R&S
® SMW-B203 or R&S ® SMW-B206
R&S ® SMW-B203 and R&S ® SMW-B20, or R&S ® SMW-B206 and R&S ® SMW-B20
R&S ® SMW-B103 and R&S ® SMW-B22, or
R&S ® SMW-B106 and R&S ® SMW-B22
(path B not equipped)
R&S
® SMW-B203 or R&S ® SMW-B206
R&S ® SMW-B203 and R&S ® SMW-B20, or R&S ® SMW-B206 and R&S ® SMW-B20
R&S ® SMW-B203 and R&S ® SMW-B22, or R&S ® SMW-B206 and R&S ® SMW-B22
The following option can be installed once, but can be used with all installed RF paths:
R&S ® SMW-B90 Phase coherence