Atec RohdeSchwarz-SMW200A - Manual (Page 20)

Version 01.02, September 2013
20 Rohde & Schwarz R&S ® SMW200A Vector Signal Generator
Measured RF frequency response with internal baseband I/Q.
Analog I/Q inputs
For each installed RF path A or B, one pair of I and Q inputs is available on the front panel (single-ended input mode). With the
R&S
® SMW-K739 option installed, the input mode for RF path A can also be switched to differential. In this mode, all four available
connectors are used for RF path A.
Analog I/Q input signals are directly applied to the analog I/Q modulation circuit and are not routed through the baseband section of
the R&S
® SMW200A.
Input mode single-ended
with R&S ® SMW-K739 option, for RF path A single-ended or differential
Connector types I, Q on front panel (for each installed RF
path A or B) BNC female
Input impedance 50 Ω (nom.)
VSWR up to 200 MHz < 1.2
200 MHz to 1 GHz < 1.35
Nominal input voltage for full-scale input
Damage voltage ±2 V
q
2 2
i
+ = 0.5 V V V