Atec RohdeSchwarz-SMW200A - Manual (Page 38)

Version 01.02, September 2013
38 Rohde & Schwarz R&S ® SMW200A Vector Signal Generator
Connectors
Front panel connectors
The following connectors are located on the front panel of the instrument.
RF 50 Ω (path A) RF output path A N female
RF 50 Ω (path B) RF output path B N female
I (path A) I modulation input signal, path A BNC female
Q (path A) Q modulation input signal, path A BNC female
I (path B) I modulation input signal, path B BNC female
Q (path B) Q modulation input signal, path B BNC female
USER 1, USER 2, USER 3 user-configurable inputs or outputs,
e.g. as trigger input or marker output BNC female
SENSOR connector for R&S ® NRP-Zxx power sensor 6-pin ODU mini-snap series B
USB USB 2.0 connector for external USB
devices such as mouse, keyboard,
R&S
® NRP-Zxx power sensors (with
R&S ® NRP-Z4 adapter cable), memory
stick for software update and data
exchange, or USB serial adapter for
RS-232 remote control
USB type A
Rear panel connectors
REF IN reference frequency input BNC female
REF OUT reference frequency output BNC female
INST TRG A trigger input for RF path A, e.g. for
frequency or level sweep BNC female
INST TRG B trigger input for RF path B, e.g. for
frequency or level sweep BNC female
USER 4, USER 5, USER 6 user-configurable inputs or outputs,
e.g. as trigger input or marker output BNC female
EFC input for electronic tuning of internal
reference frequency BNC female
LO IN phase-coherent LO input SMA female
LO OUT phase-coherent LO output SMA female
IEEE 488 remote control of instrument via GPIB 24-pin Amphenol series 57 female
DISPLAY PORT for future use
DVI for future use
LAN provides remote control functionality and
other services, see section “Remote
control” RJ-45
USB IN USB 2.0 (high speed)
remote control of instrument (USB-TMC) USB type B
USB DEVICE USB 2.0 (high speed) connector for
external USB devices such as
mouse and keyboard for enhanced
operation,
R&S
® NRP-Zxx power sensors (with
R&S ® NRP-Z4 adapter cable) for external
power measurements and level
adjustment of instrument,
memory stick for software update and data
exchange,
USB serial adapter for RS-232 remote
control
USB type A
LAN provides remote control functionality and
other services, see section “Remote
control” RJ-45
IEEE 488 remote control of instrument via GPIB 24-pin Amphenol series 57 female
EXT 1, EXT 2 inputs for external analog modulation
signals BNC female
DIG I/Q OUT 1, DIG I/Q OUT 2 digital output connectivity in line with
R&S
® Digital I/Q Interface to connect to the
R&S ® EX-IQ-Box, for example
26-pin MDR