Atec Agilent-N9010A - Manual (Page 18)

18
Rear panel
Noise source drive +28 V (pulsed)
Connector BNC female
SNS Series noise source connector For use with Agilent SNS Series noise sources
Analog out
Connector BNC female (used by Option YAS)
USB 2.0 ports
Master (4 ports)
Standard Compatible with USB 2.0
Connector USB Type-A female
Output current 0.5 A nominal
Slave (1 port)
Standard Compatible with USB 2.0
Connector USB Type-B female
Output current 0.5 A nominal
GPIB interface
Connector IEEE-488 bus connector
GPIB codes SH1, AH1, T6, SR1, RL1, PP0, DC1, C1, C2, C3, C28, DT1, L4, C0
GPIB mode Controller or device
LAN TCP/IP interface
Standard
Connector
1000Base-T
RJ45 Ethertwist
IF output
Connector
Impedance
SMA female, shared by Option CR3 and CRP
50 Ω nominal
Wideband IF output, Option CR3
Center frequency
SA mode or I/Q analyzer with IF BW ≤ 25 MHz
with Option B40
322.5 MHz
250 MHz
Conversion gain –1 to +4 dB (nominal) plus RF frequency response
Bandwidth
Low band Up to 140 MHz (nominal)
High band, with preselector Depends on center frequency
High band, with preselector bypassed Up to 410 MHz (nominal)
Programmable IF output, Option CRP
Center frequency
Range
Resolution
10 to 75 MHz (user selectable)
0.5 MHz
Conversion gain –1 to +4 dB (nominal) plus RF frequency response
Bandwidth
Output at 70 MHz center
Low band or high band with preselector bypassed 1 100 MHz (nominal)
Preselected band Depends on RF center frequency
Lower output frequencies Subject to folding
Residual output signals ≤ –88 dBm (nominal)
1. Option MPB installed and enabled.