Alpha Technologies INEX Inverter System - Manual (Page 35)

Argus Technologies Ltd. 014-114-C0 Rev D WC
Printed in Canada. © 2008 Argus Technologies Ltd. ARGUS and INEX are registered trademarks of Argus Technologies Ltd. All Rights Reserved. Page 25 of 43
Main menu->Alarm->Active Alarm
Item Specification Remark
Inverter Serial number, Alarm name, Event time
STS Serial number, Alarm name, Event time
SMR (N/A) Serial number, Alarm name, Event time
For example:
1. Inv xxxxxxxxx
Fan Fault
yyyy-mm-dd
hh:mm:ss ▼
Table E–LCD display of alarm log
6.3 Parameter Setting
INEX inverter system allows some parameters to be adjusted through the controller module.
1. Use PgDn key and Enter key to select SETTING.
2. A four-digit numeric password is required. Use PgUp key to increase number, and PgDn key to decrease
number.
For example, press PgUp key once for 1, twice for 2,
three times for 3, and so on.
3. Press Enter to validate each digit of the
password once the desired number is selected.
The default password is 1234.
No setting modification can be executed if a wrong password is
entered.
SETTING section is divided into two categories: MODULE and SYSTEM.
Parameters of modules can be modified or adjusted under MODULE while system-related setups can be done
under SYSTEM. The following sections refer to detailed setup procedures.
NOTE: To activate system level changes, cycle the system power off then on again.
6.3.1 Password Setting
A new password can be set in SYSTEM option under SETTING.
1. Press Enter key to enter SETTING PASSWORD menu for resetting the
password.
2. Use PgUp key and PgDn key to select a number.
3. Press Enter to validate each digit of the password once the desired number is
selected.
4. After the new four-digit password is input, the system will prompt the user to re-enter
the new password as confirmation. Input the new password again.
Once the password is successfully changed, DONE will appear on the screen.