Extron Electronics MLC 104 IP Series Setup Guide User Manual
Setup guide, Medialink, Controllers
This manual is related to the following products:
Table of contents
Document Outline
- Chapter One
- Introduction
- Chapter Two
- MLC 104 Hardware Setup
- Chapter Three
- MLC 104 Series Software Setup
- Step 1: Download Device Drivers
- Step 2: Create a New Project
- Step 3: Add an MLC 104 IP or MLC 104 Controller and Define its Location
- Step 4: Define E-mail Settings (IP model only)
- Step 5: Add a Serial or IR Device
- Step 6: Configure the Front Panel Buttons
- Step 7: Create a Display Shutdown Schedule
- Step 8: Create a Display Lamp Hour Warning E-mail (IP model only)
- Step 9: Create a Display Disconnection E-mail (IP model only)
- Step 10: Build and Upload a Configuration