Extron Electronics MLC 104 IP Series Setup Guide - Manual (Page 15)

MLC 104 Series MediaLink Controllers • Software Setup
Software Setup, cont’d
3-6 MLC 104 Series MediaLink Controllers • Software Setup 3-7
Add Device dialog box (Advanced)
(for IP version only)
5. Select the Auto Configure IP Address check box. The
MAC Address text box becomes active and the first three
octets of the MAC address appear.
6. Locate the MAC address on the rear of the Extron IP
product or obtain it from your network administrator.
7. Enter the remainder of the MAC address in the MAC
Address text box (the first three octets should be filled in).
8. Click the Set button. This assigns the new IP address to
the IP device.
9. Click the New Location button in the upper right corner of
the Add Device dialog box. A Location folder is created,
in edit mode. You can use additional folders to create up
to eight location levels.
10. Assign a location-oriented name to the highlighted folder
(e.g., Room 201).
11. Once finished, click the OK button. The
Global Configurator Front Panel window appears, as
shown on the following page.
To add the MLC 104, do the following:
1.
From the IP Link Device drop-down menu, select
MLC 104 .
2. Select a serial port number (if more than one is available).
3. Click the OK button. The Global Configurator front panel
window appears, as shown below.
The Global Configurator Front Panel window
N This Global Configurator project can be saved at any time
by selecting Save from the File menu.
Step 4: Define E-mal Settngs (IP model only)
Global Configurator supports scheduling, monitoring, and
e-mail alerts for all connected devices (e.g., a video projector).
For example, you can create a schedule to shut down a projector
at a predetermined time, and/or create an e-mail alert that
warns a school administrator if the projector's lamp hours are
nearing expiration.