Extron Electronics MLC 104 IP Series Setup Guide - Manual (Page 4)

MLC 104 Series MediaLink • Table of Contents
Table of Contents
Chapter One • Introducton .................................................... 1-1
About this Manual ..................................................................... 1-2
About the MLC 104 Medialink Controllers ......................... 1-2
About Global Configurator ..................................................... 1-3
System Requirements ................................................................ 1-4
Installing the Software ............................................................. 1-4
Updating Firmware .................................................................... 1-5
Chapter Two • MLC 104 Seres Hardware Setup ....... 2-1
Right Side Panel Features and Connections ...................... 2-2
Left Side Panel Features and Connections ......................... 2-6
Front Panel Features and Basic Operation ......................... 2-7
Buttons .................................................................................... 2-7
Volume control ........................................................................ 2-8
Configuration (host control) port .......................................... 2-8
Chapter Three • MLC 104 Seres Software Setup ..... 3-1
Step 1: Download Device Drivers ........................................ 3-3
Step 2: Create a New Project ................................................ 3-4
Step 3: Add an MLC 104 IP or MLC 104 Controller and
Define its Location
..................................................................... 3-5
Step 4: Define E-mail Settings (IP model only) ................ 3-7
Defining e-mail server settings.............................................. 3-8
Setting up e-mail notifications .............................................. 3-8
Adding e-mail contacts ......................................................... 3-10
Step 5: Add a Serial or IR Device ........................................ 3-11
Downloading additional drivers.......................................... 3-11
MLC 104 series port configuration...................................... 3-11
Adding a serial driver ...........................................................3-11
Adding an IR driver ...............................................................3-12
Step 6: Configure the Front Panel Buttons ..................... 3-14
Configuring an input button................................................ 3-14
Configuring the On and Off buttons................................... 3-15
Step 7: Create a Display Shutdown Schedule ................ 3-16
Step 8: Create a Display Lamp Hour Warning E-mail
(IP model only)
.......................................................................... 3-18