Adding e-mail contacts, Step 5: add a serial or ir device, Downloading additional drivers – Extron Electronics MLC 104 IP Series Setup Guide User Manual
Page 17: Mlc 104 series port configuration, Adding a serial driver, Adding e-mail contacts -10, Step 5 : add a serial or ir device, Adding a serial driver -11, Software setup, cont’d, Step 5 : add a seral or ir devce
MLC 104 Series MediaLink Controllers • Software Setup
Software Setup, cont’d
3-10
MLC 104 Series MediaLink Controllers • Software Setup
3-11
Addng e-mal contacts
To add e-mail contacts, do the following:
1
.
From the Edit menu, choose Contact Manager. A dialog
box appears.
2
.
Fill in the name, e-mail address, and the company areas of
the Contact Manager dialog box.
Contact Manager dialog box
3
.
Click Add to add the newly-created contact to the list.
4
.
Click OK to close the dialog box.
Step 5: Add a Seral or IR Devce
Adding an A/V device (projector displays, VCRs, DVDs, etc.)
for an MLC to control requires that you first add the device’s
driver to the GC configuration.
Downloadng addtonal drvers
If you successfully downloaded device drivers in
"Step 1: Download Device Drivers", proceed to "MLC 104 port
configuration" below.
If you have not downloaded or need additional device drivers
for your open project, you'll need to save and close the current
project to access new drivers. To do so,
1.
Select New from the File menu, but click the Yes button
when prompted to save.
2.
If the file was not previous saved, you must enter a project
name in the Project Name field.
3.
Click the OK button. This automatically closes the current
project.
4.
Click the Add Drivers Subscription button on the start
options dialog.
5.
Follow the instructions under "Step 1: Download Device
Drivers".
6.
Reopen the saved project by choosing Open An Existing
Project
from the list of options.
You are now ready to add A/V devices to the configuration
using the new drivers.
MLC 104 seres port configuraton
The MLC 104 and MLC 104 IP have a single port that you
can configure to use for a serial or IR device. The following
illustrates how to add a projector or a DVD using each type of
driver.
Addng a seral drver
1.
From the IP Link tab (on the left pane), select the port
named Display.
2.
Use the drop-down menus under Serial Driver Selection
to select device type (choose video projector), and
manufacturer (choose Epson). For this example, select the
Epson PowerLite 7700p
video projector from the Available
Drivers
field.