Extron Electronics MLC 104 IP Series Setup Guide - Manual (Page 21)

MLC 104 Series MediaLink Controllers • Software Setup
Software Setup, cont’d
3-18 MLC 104 Series MediaLink Controllers • Software Setup 3-19
Step 8: Create a Dsplay Lamp Hour Warnng
E-mal (IP model only)
Global Configurator’s monitoring feature enables you to
configure a MLC 104 IP controller to monitor many parameters
of the connected display devices. For example, a monitor alert
can warn the school administrator if a display lamp hour limit
is close to expiration, or if a display is inexplicably disconnected
from the MLC 104 IP controller.
To set a display lamp hour warning e-mail, do the following:
1
. Click the Monitor tab in the Global Configurator window.
2 . Click the Add Monitor button below the Monitored
Conditions dialog. The Monitored Conditions Wizard
dialog appears.
3 . Enter a name (e.g., Lamp hour) in the Enter Monitored
Condition Name field area. The label now appears in the
left pane.
4 . Click the Next button to specify a condition. This takes
you to the actions page, where you can specify the action.
Monitored Conditions Wizard dialog
5 . In the Subject Port window, select the display
(choose Epson PowerLite 7700p) for which the lamp hour
warning is to be set. A list of monitoring options appears
under the Available Options window.
6 . Set the lamp hour limit by doing the following:
a
. Choose Lamp Usage Time (hours): Value under the
Available Options window.
b . Enter a value (e.g., 800) in the Lamp Usage Time
(hours) box.
c . Click Apply Condition for each condition assigned.
d . Click Next.
7 . Click Next again to add an e-mail notification.
8 . Click on the appropriate e-mail message and contacts,
then click Apply Email/Contacts.