Extron Electronics MVX 44_48_84_88 Series User Guide - Manual (Page 60)

Audio-Output Volume settings — Displays the RGB Delay/Mute/Output-Volume Adjust
window (see figure 35 on the preceding page), which displays the output volume level,
consumer (-10 dBV) or professional (+4 dBu), for a single output or for all outputs and
allows you to change it. This window also displays the RGB delay settings and allows
you to change it and allows you to mute and unmute the video and audio output.
Mute-Output settings — Displays the RGB Delay/Mute/Output-Volume Adjust window
(see figure 35 on the preceding page), which allows you to mute and unmute the video
and audio output for a single output or for all outputs. This window also displays the
RGB delay and output volume level settings and allows you to change them.
Update Firmware ... — Allows you to replace the firmware that is coded on the control
board of the switcher without taking the switcher out of service. See “ Updating the
firmware ” on page 49.
Name Presets — Allows you to name each of the 16 memory presets.
Show RS-232 Strings — Displays the ASCII commands that are used by the current
configuration. You can refer to these for RS-232 programming.
Initialize — Initializes and clears any or all of the following: ties, presets, RGB delay,
audio configuration, preset titles, icon names, and icons.
Audio Input Configuration selection
Displays the Configure Audio Options window (see figure 36 on the preceding page), which
shows the audio gain level settings for each input and allows you to change them.
Preferences menu
Immediate Changes — Causes changes to take effect immediately.
Hold/Verify Changes — Delays implementation of changes until the
Changes – Take button is pressed.
Ties as Lines — Displays ties as lines (see figure 37 ).
Figure 37. Ties Shown as Lines
MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Remote Operation 54