Extron Electronics MVX 44_48_84_88 Series User Guide - Manual (Page 52)

Matrix Switchers Control Program
The Matrix Switchers Control Program communicates with the switcher via the rear panel
Remote RS-232 port to provide an easy way to set up ties and sets of ties. The program is
compatible with Windows 2000, Windows XP, Windows 7, and newer operating systems.
Updates to the program can be downloaded from the Extron website (
www.extron.com ).
Installing the Software
The program is contained on the Extron Software Products DVD. Install the software as follows:
NOTE: For full functionality, install both of the following programs:
• The Matrix Switchers Control Program
• The Firmware Loader
1. Insert the DVD into the drive. The Extron software DVD window should appear
automatically (see
figure 25 ).
Figure 25. Software DVD Window
NOTE: If the window does not self-open, run Launch.exe from the DVD.
2. Click the Software tab (see figure 25 ).
3. Scroll to the desired program and click Install (see figure 26 ).
Figure 26. Software Installation
MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Remote Operation 46