Extron Electronics IPL T PC1i Setup Guide User Manual
Ip link power control interface, Setup guide, Setup guide checklist
This manual is related to the following products:
Table of contents
Document Outline
- Introduction
- Hardware Setup
- Software Setup
- Creating a Global Configurator Project File
- Step One: Download device drivers.
- Step Two: Create a new project.
- Step Three: Add a device.
- Step Four: Define the location of the new device.
- Step Five: Save the new Global Configurator file.
- Step Six: Enter contacts.
- Step Seven: Create e-mail messages.
- Step Eight: Enter output receptacle and contact input port labels.
- Step Nine: Assign device drivers.
- Step Ten: Set scheduled actions and e-mail deliveries.
- Step Eleven: Set monitored conditions.
- Building and Uploading a GC File
- Launching the GlobalViewer Interface
- Creating a Global Configurator Project File