Extron Electronics HSA 822M User’s Manual - Manual (Page 15)

HSA 822M • Installation
Installation, cont’d
HSA 822M
3
Chapter Three
Maintenance and Modifications
Replacing an AAP
Replacing the Bezels
Removing and Replacing the Enclosure
Setting the Upper Limit Switch (Elevated Platform Height)
Setting the Lower Limit Switch (Lowered Platform Height)
Setting the Manual Release Switch
Safety Switch — Location Only
Replacing the Control Board Assembly and Power Supply Assembly
2-16
Bezel
Blank Bezel
Plug-in in AAP
Panel
Bezels
The HSA 822M ships with RJ-45/RJ-11 connector bezel plug-ins
in a variety of colors and a black, blank bezel.
To change to a different color RJ-45 connector
bezel or if an RJ-45 connector is not needed or
desired, replace the connector bezel plug-in on
the AAP/RJ-45 panel with a bezel of a different
color or a blank plug-in. See “Replacing the
Bezels” in chapter 3.
If no RJ-45 connector is desired, snap
the interior RJ-45 cable onto the rear of
the blank bezel plug-in (shown at
right) to hold it conveniently out of the
way. Retain the removed connector
bezel plug-in for any possible later
use.