YSI MultiLab 4010P-1 - Manual (Page 73)

MultiLab 4010-1 Data storage
ba76141e03 03/2014 73
10 Data storage
You can save measured values (datasets) to the data storage:

Manual data storage (see section 10.1 M ANUAL DATA STORAGE , page 73)
 Automatic data storage at intervals (see section 10.2 A UTOMATIC DATA STOR -
AGE AT INTERVALS
, page 74)
Each data storage process transmits the current dataset to the USB interface.
10.1 Manual data storage
You can save a measurement dataset to the data storage as follows. The data-
set is at the same time output to the USB interface:
If the data storage is
full
When all data storage locations are occupied, it is not possible to continue stor-
ing. Then you can e.g. transmit the stored data to a PC (see section 10.3.1
E
DITING THE MEASURED VALUE DATA STORAGE , page 76) and subsequently erase
the data storage (see section 10.3.2 E RASING THE MEASUREMENT DATA STOR -
AGE , page 77).
1. Press the key shortly.
The menu for manual data storage appears.
2. If necessary, change and confirm the ID number (1 ... 10000) with
<><> and
03.04.2013 07:43:33
pH 7.000 24.8 °C AR +++
ID number: 1
continue
Manual data storage 4 von 500
03.04.2013
08:00
Back