YSI MultiLab 4010P-1 - Manual (Page 72)

Settings MultiLab 4010-1
72 ba76141e03 03/2014
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the
9.6.2 Resetting the system settings
The following system settings can be reset to the default condition:
The system settings are reset in the menu, Storage & config / System / Reset.
To open the Storage & config menu, press the
Setting Default settings
Language English
Audio signal on
Baud rate 4800 Baud
Output format ASCII
Decimal separator .
Contrast 50
Illumination Auto
Shutoff time 1 h
Temperature unit °C
Stability control on